Philips HTS5310S/51 user manual Press Disc on the remote to turn on the DVD system, If no picture

Getting Started (continued)

E n g l i s h

Setting up Progressive Scan feature (for Progressive Scan TV only)

The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality.

IMPORTANT!

Before enabling the progressive scan feature, you must ensure :

1)Your TV can accept progressive signals, a progressive scan TV is required.

2)You have connected the DVD system to your TV using Y Pb Pr (see page 12).

1 Turn off your TV progressive scan mode or turn on interlaced mode (refer to your TV user manual).

2Press DISC on the remote to turn on the DVD system.

3Turn on your TV and select the correct Video Input channel (see page 19).

➜ The blue DVD background screen will appear on the TV.

4Press SETUP on the remote.

5Press 2 to select { Video Setup Page }.

Video Setup Page

TV Type

TV Display

Progressive

Picture Setting

Component

6Select { Component } > { YUV }, then press OK to confirm.

7Select { Progressive } > { On }, then press OK to confirm.

➜ The below menu will appear on the TV.

HINTS:(refer to the owner's manual)

ACTIVATING PROGRESSIVE:

1.Ensure your TV has progressive scan.

2.Connect with YPbPr(GBR) video cable.

3.If there is a blank screen on normal TV, wait 15 seconds for auto recover.

OK Cancel

8 Press 1 to highlight		in the menu
	OK
and press OK to confirm.

There will be no picture on your TV at this state until you turn on the progressive scan mode on your TV.

9Turn on your TV progressive scan mode (refer to your TV user manual).

➜ The below menu will appear on the TV.

Confirm again to use progressive scan

If picture is good press OK on remote

OK Cancel

0 Press 1 to highlight		in the menu
	OK
and press OK to confirm.

➜The set up is complete now and you can start enjoy the high quality picture.

If no picture:

●Wait for 15 seconds for auto recovery.

OR

1Deactivate Progressive Scan feature by pressing the OPEN CLOSE 0 on the DVD system to open the disc tray.

2Press 1 on the remote control.

3Press MUTE on the remote.

➜ The blue DVD background screen will appear on the TV.

Helpful Hint:

–There are some progressive scan TV and High-Definition TV sets that are not fully compatible with this DVD system, resulting in the unnatural picture when playing back a DVD VIDEO disc in the progressive scan mode. In such a case, turn off the progressive scan feature on both the DVD system and your TV set.

TIPS: The underlined option is the factory default setting.

To return to the previous menu, press 1. To remove the menu, press SETUP.

20