11
SERIAL
RS-232
VGA USB
"B"
USB
RETENTION
BRACKET
DVI-D
TOUCH SCREEN
CABLES
VIDEO CABLES
(AUTO ADJ)
MENU DOWN
SELECT UP
(VGA / DVI) POWER
Connection of VGA and Touch Screen Cables
Connect either a 15-pin VGA or DVI-D cable and either an RS-232 or USB cable if the monitor is
equipped with a touch screen. All c ommunication cables should include a chassis ground shield.
Hazardous location, Division 2, requires that all cables have adequate strain relief. For this reason,
tighten al l connector thumb screws securel y. If a USB cable is being used, install the provided USB
retention bracket. Insert the USB connector through the square cutout in the base of the brac ket and pull
the cable and body of the connector back through the round hole in the bracket flange. Now insert the
bracket into the two slots on the rear of the monitor a nd side it forward so the connector is fully inserted in
the mating bulkhead connector. Install and tighten two 4-40 x .25” Philips screws.
NOTE: TO PREVENT INADVERTENT DISCONNECTION OF VIDEO AND/OR
SERIAL TOUCHSCREEN CABLES ASSURE THAT THE THUBSCRE WS ARE
SUFFICIENTLY TIGHTENED.
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT
WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREE
OF IGNITABLE CONCENTRATIONS.
NOTE: WHEN USING USB T OUCHSCREEN CONNECTION THE USE OF THE
USB RETENTION BRACKET IS REQUIRED FOR HAZARDOUS LOCATIONS
AND HIGHLY RECOMMENDED FOR NONHARDAOUS LOCATIONS.
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT
WHILE THE CIRCUIT IS LIVE OR UNLESS THE AREA IS KNOW TO BE FREE
OF IGNITABLE CONCENTRATIONS.