Installation
Using AC power
1Make sure all connections have been made before switching on the power supply.
2Connect the power cable supplied to
AC ~ and to the wall socket.This switches on the power supply.
When the system is switched to standby, it is still consuming some power. To disconnect the system from the power supply completely, remove the power plug from the wall socket.
The type plate is located on the rear of the set.
Inserting batteries into the remote control
Insert two batteries type R06 or AA into the remote control with the correct polarity as indicated by the "+" and
1
2
3
English
CAUTION!
–Remove batteries if they are exhausted or will not be used for a long time.
–Do not use old and new or different types of batteries in combination.
–Batteries contain chemical substances, so they should be disposed off properly.
13
