10 EN

4 Get started

Caution
•Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•Risk of explosion! Keep batteries away from heat,
sunshineorre.Neverdiscardbatteriesinre.
•Risk of decreased battery life! Never mix different
brands or types of batteries.
•Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery: [Fig. 8]
1 Open the battery compartment.
2 Insert the supplied AAA batteries with
correct polarity (+/-) as indicated.
3 Close the battery compartment.
a
b
c

Set clock

1 In standby mode, press and hold CLOCK
SET on the remote control for more than
two seconds.
» [24H] or [12H] hour format is
displayed.
2 Press / (or +/-) to select [24H] or
[12H] hour format
3 Press CLOCK SETtoconrm.
» The hour digits are displayed and begin
to blink.
4 Repeat steps 2-3 to set hour and minute.
Note
•If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•You can view clock information in Eco power mode by
pressing CLOCK SET.

Turn on

Press .
» The unit switches to the last selected
source.
Switch to standby mode
Press again to switch the unit to standby
mode.
» The clock (if set) is displayed on the
panel.
Switch to ECO standby mode:
Press and hold for more than two seconds.
» The display panel is dimmed.