30
English
Clock/TimerClock setting
See "Preparations-Step 2: Setting the clock".
Timer setting
●The system can be used as an alarm clock,
whereby DISC or TUNER is switched on at a set
time (one time operation). The clock time needs
to be set first before the timer can be used.
1In standby mode, press and hold SLEEP/
TIMER on the remote control for more than
three seconds.
➜"SET TIMER" is displayed briefly. Then, the
hour digits flash on the display panel.
2Press DISC or TUNER to select the desired
source.
●Before setting timer, make sure the music source
has been prepared.
DISC – load the disc.
TUNER – tune to the desired radio station.
3Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the hours and press
SLEEP/TIMER to confirm.
➜The minute digits flash on the display panel.
4Press VOLUME +/- on the front panel or VOL
+/- on the remote to set the minutes and press
SLEEP/TIMER to confirm.
➜The timer is now set and activated.
5In standby mode, press SLEEP/TIMER on the
remote control to activate or deactivate the
timer.
➜Display shows if activated, and disappears
if deactivated.
Sleep timer setting
The sleep timer enables the system to switch off
by itself after a set period of time.
1In active mode, press SLEEP/TIMER on the
remote control repeatedly to select a preset
time.
➜The selections are as follows (time in
minutes):
SLEEP OFF ™ SLEEP 90 ™ SLP 80 ™
SLEEP 70 ™ SLEEP 60 ™ SLEEP 50 ™
SLEEP 40 ™ SLEEP 30 ™ SLEEP 20 ™
SLEEP 10™ SLEEP OFF
➜“SLEEP XX“ or “OFF” is displayed. “XX“
denotes the time in minutes.
ß
2When you reach the desired length of time, stop
pressing the SLEEP/TIMER button.
To deactivate the sleep timer
●Press SLEEP/TIMER repeatedly until "SLEEP
OFF" is displayed, or press ECO POWER/
STANDBY ON y (or y on the remote).
2;
pg001-pg034_MCD119-05-Eng 2007.8.10, 17:0030