![](/images/new-backgrounds/1164652/16465231x1.webp)
4 Get started
Caution
•Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the back of the apparatus.Write the numbers here: Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•Risk of explosion! Keep batteries away from heat, sunshine or fi re. Never discard batteries in fi re.
For fi
1Remove the protective tab to activate the remote control battery.
To replace the remote control batteries:
1Open the battery compartment.
2Insert one lithium CR2025 battery with correct polarity
3Close the battery compartment.
|
| Note |
| English | |
|
|
| |||
|
|
|
| ||
• | Before you press any function button on the remote | ||||
|
| ||||
| control, fi rst select the correct source with the remote |
|
| ||
| control instead of the main unit. |
|
| ||
• If you are not going to use the remote control for a |
|
| |||
| long time, remove the battery. |
|
| ||
|
|
|
|
|
Set clock
1In the standby mode, press and hold CLOCK on the front panel to activate the clock setting mode.
»The hour digits are displayed and begin to blink.
2Press +VOL - to set the hour.
»The minute digits are displayed and begin to blink.
3Press +VOL - to set the minute.
4Press CLOCK to confi rm the clock setting.
Turn on
1 Press .
»The unit switches to the last selected source.
2Wait for automatic setup of wireless connection between the main unit and subwoofer.
»[PAIRING] (pairing) fl ashes.
»If the connection succeeds, [PAIR OK]
(pair OK) and are displayed and the blue indicator on the subwoofer lights up.
»If the connection fails, [PAIR FAIL] (pair fail) is displayed and the green indicator on the subwoofer lights up.
»If the wireless connection fails, set up the connection manually.
EN 17