Philips MCD510/21 manual Connections, Right, Left, Placing speakers

							Connections
							English
					S-VIDEO	Cr	FM wire
					IN
					AUDIO
					IN		antenna
						Cb
					VIDEO IN		MW loop
						Y
							antenna
		DIGITAL			3
		OUT
speaker	R	LINE OUT	L	FM/MW ANTENNA			speaker
				FM 75Ω
(right)	R		L	AM ANTENNA	FM ANTENNA		(left)
		AUX/
		CDR IN
	SUB
	WOOFER OUT
		+
		R
		L
		+
		SPEAKERS 6Ω
							5
							AC power cord

IMPORTANT!

–The type plate is located at the rear of the system.

–Before connecting the AC power cord to the wall outlet, ensure that all other connections have been made.

–Never make or change any connections with the power switched on.

–The voltage selector located at the bottom of this system is preset at 220V-240V from the factory. For countries that operate at 110V-127V, please adjust to 110V-127V before you switch on the system.

To avoid overheating of the system, a safety circuit has been built in.Therefore, your system may switch to Standby mode automatically under extreme conditions. If this happens, let the system cool down before reusing it (not available

for all versions).

Step 1: Placing speakers

Front	Front
speaker	speaker
( left )	( right )

VIEWING AREA

Place the front left and right speakers at equal distances from the TV set and at an angle of approximately 45 degrees from the listening position.

Notes:

-To avoid magnetic interference, do not position the front speakers too close to your TV set.

-Allow adequate ventilation around the DVD System.

11