Basic Functions

English

M I C R O S Y S T E M M C M 1 9 6 D

 

 

IMPORTANT:

To exit without storing the Plug and Play

PressÇon the system.

If you do not complete the Plug and Play installation, the function will be restarted when you next turn on the main supply again.

Notes:

If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" will be displayed.

During Plug and Play, if no button is pressed within 15 seconds, the system will exit Plug and Play mode.

Before you operate the system, complete the preparation procedures.

Plug and Play (for tuner installlation)

Plug and Play allows you to store all available radio stations automatically.

First time setup/power up

1When you turn on the main supply, "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅ on the system to start installation.

"PLUG AND PLAY" .... "INSTALL" is displayed, followed by "TUNER" and "AUTO".

PROG starts flashing.

The system will automatically store the radio stations with sufficient signal strength, starting from FM, then followed by AM band.

When all the available radio stations are stored or the memory for 40 presets are used, the last preset radio station will be played.

To reinstall Plug and Play

1In standby mode, press and holdÉÅon the system until "AUTO INSTALL - PRESS PLAY" is displayed.

2PressÉÅagain to start installation.

All previously stored radio stations will be replaced.

14

Page 14
Image 14
Philips MCM196D quick start Basic Functions, To exit without storing the Plug and Play, First time setup/power up