20
Installation
Only For Qualified Installers
| Venting and Installation |
1 | 3 |
Feed chimney liners down the chimney and through the damper.If the fireplace opening does not allow enough room to connect the flue liners to the stove it is necessary to separate the exhaust/ intake pipe adapter from the stove body. Approximately 4 inches clearance above the top of the glass door is needed to allow connection of the liners. This must be determined by the installer.
Remove the screw, washer and spacer from the center of the rear brick panel. Using one hand, gently push out on the side brick /relief door to allow clearance for removing the rear brick panel.
2 | 4 |
Door Latches
Open the glass door by pulling out on the 2 latches located on the bottom of the door frame. Pull the bottom out a couple of inches and lift the door off of the stove body and set safely out of the way. Remove the bag of rock wool, packaging materials and log set from inside the firebox.
Skip steps 3 thru 5 if intake / exhaust adapter does not need removed for installation.
Remove 2 screws holding exhaust cover plate onto the rear of the firebox and remove cover.
