Tuner Operations
IMPORTANT! | Using the Plug and Play | |
Make sure the FM and MW antennas are | ||
Plug and Play allows you to store all available | ||
connected. | ||
radio stations automatically. | ||
|
English
Tuning to radio stations
1Press TUNER to enter tuner mode.
To select another waveband (FM or MW), press TUNER again.
2Press and hold à or á until the frequency indication starts to change, then release.
➜The system automatically tunes to the next strong signal radio reception.
➜
lights up for FM stereo reception.
➜RDS lights up for RDS station (in FM band only).
For tuning to a weak signal station
●Press à or á briefly and repeatedly until an optimal reception is found.
Presetting radio stations
You can store up to 40 preset radio stations in the memory, starting from FM and followed by MW bands.
Helpful Hints:
–The system will exit presetting mode if no button is pressed within 20 seconds.
–If no stereo frequency is detected during Plug and Play, "CHECK ANTENNA" appears.
M I C R O S Y S T E M
IR
1Connect the system to the power supply,
"AUTO INSTALL Ð PRESS PLAY" appears.
OR
In Eco Power standby/standby mode, press and hold ÉÅ on the main unit until "AUTO INSTALL Ð PRESS PLAY" appears.
2Press ÉÅ on the main unit to start installation.
➜"INSTALL TUNER AUTO" appears.
➜All previously stored radio stations will be replaced.
➜Once completed, the last tuned radio station (or the first available RDS station) will play.
3If the first preset is a RDS station, it will proceed to set the RDS clock.
➜"INSTALL" appears, then "TIME" and
" SEARCH RDS TIME".
➜When RDS time is read, " RDS TIME" will appear and the current time will be stored.
➜If RDS station does not transmit RDS time within 90 seconds, ÒNO RDS TIMEÓ will appear and the programme will exit automatically.
17
