Philips 1VMN29896, MDR515H / F7 SETTING THE CLOCK, 32 EN, Use, Use, Use, ] to select, Press [STANDBY/ON, Auto Clock Setting, Press [MENU] to exit, Press [MENU] and use

Press [MENU] to exit.

Press [STANDBY/ON y] to turn the unit to the standby mode.

This unit will search for the time only when the power is in the standby mode. Initially leave it in standby mode for at least 15 minutes to give this unit time to set the clock. Once the clock is set, the unit receives the clock data at 12:00 am & 12:00 pm when unit is in standby mode. Check the time after the Auto Clock was set, if it is incorrect time then set the “Auto Clock Setting“ to “OFF” in step 4 above. Then try “Manual Clock Setting“ on page 34.

5

6

OFF

Auto Manual

Auto Clock Setting

“Clock” menu will appear.

“General Setting” menu will appear.

Press [MENU] and use [K/ L] to select “General Setting”, then press [OK].

1

2 Use [K/ L] to select “Clock”, then press [OK].

3 Use [K/ L] to select “Auto Clock

Setting”, then press [OK].

4 Use [K/ L] to select “Auto”, then press [OK].

Analog Auto Clock Setting (Cable TV only)

SETTING THE CLOCK

Auto Clock Setting

This unit can set the time and date automatically by referring to a channel that carries a clock information. If a PBS (public broadcasting station) is available on Cable in your area, follow “Auto Clock Setting” below. If not, follow “Manual Clock Setting” on page 34.

Make sure

•The cable TV connections are correct.

•Channels are set. (Refer to page 29.)

Note

• The clock may set itself automatically after you connect the antenna/cable signal and plug in the power cord.

• Only the Analog PBS channel Cable TV signal is effective for auto clock setting.

• For analog auto clock setting, incorrect time may be obtained depending on the broadcast information. If this occurs, set the “Auto Clock Setting” to “OFF” at step 4 above and try “Manual Clock Setting” on page 34

32 EN