Philips PET1031/12 Another disc, Player does not Aim the remote control directly at, Control

Disc can’t be played	• Ensure the disc label is upwards.
	• Clean the disc.
	• Check if the disc is defective by trying
	another disc.
The player does not	Aim the remote control directly at the
respond to the remote	sensor on the front of the player. Avoid all
control	obstacles that may interfere with the signal
	path. Inspect or replace the batteries.
Distorted or B/W pic-	Use only discs formatted according to the
ture with DVD	TV-set used (PAL/NTSC).
No audio at digital output	• Check the digital connections.
Player does not respond	• Operations are not permitted by the disc.
to all operating com-	• Refer to the instructions in the disc inlay.
mands during playback
Cannot detect USB	• Unplug the USB connection and plug-in
plug-in	again. Detection may take some time that
	vary with the capacity of your USB device.
	• The DVD player only support Mass Storage
	(MSC) format from USB flash drive.
	• The DVD player does not support Hard
	Disk storage or Media Transfer Protocol
	(MTP) format.
Switch between	• DVD mode is default source during the
DVD/USB	DVD player power on.
	• Plug in USB will activate USB mode.
	Deactivate it by unplug the connection.
	• Unplug the connection before you plug-
	in another connection.
Player feels warm	When the player is in use for a long period of
	time,the surface will be heated.This is normal.
Display goes dimmer	The unit is saving power to ensure longer
when AC is unplugged	playtime with battery. It is normal. Adjust
	the brightness in the SETUP menu.