English
Problem | Possible cause | Solution |
The Jet Clean System does not work when I press the on/off button.
Water leaks from the shaver after cleaning.
The cleaning fluid level is too low. If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program aborts.The cleaning symbol and the ‘fluid low’ symbol flash at intervals and the holder returns to its starting position.
You have used another cleaning fluid than the original Philips cleaning fluid.
You have not closed the locking lever of the Jet Clean System properly, or you have not placed the shaver in the Jet Clean Shaver properly. In these cases the Jet Clean System starts to operate, but the cleaning program is not performed properly.
The Jet Clean System is not connected to the mains.
This is normal and not dangerous.
Refill the cleaning chamber with cleaning fluid up to the MAX level (see section ‘Cleaning the shaving unit in the Jet Clean System’ in chapter ‘Cleaning and maintenance’).
Only use Jet Clean solution HQ200.
Place the shaver without protection cap in the Jet Clean System properly. Close the locking lever properly.
Put the small plug in the Jet Clean System and put the adapter in the wall socket.
During rinsing some water may collect between the power unit and the housing. After rinsing this water flows out through the socket.The power unit is completely watertight so water cannot reach the electronic parts of the shaver.Your shaver continues to be absolutely safe.
38
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PT729CC_A6_CS3.indd 38 |
|
| 13.4.26 2:47:22 PM | ||||||
