English

Do not put the shaver back into the plugged-in Jet Clean System after you have removed the rechargeable battery.

Do not connect the shaver to the mains again after you have removed the rechargeable battery.

guarantee and support

If you need information or support, please visit www.philips.com/ support or read the separate worldwide guarantee leaflet.

guarantee restrictions

The shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear.

Troubleshooting

This chapter summarises the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Centre in your country.

Problem

Possible cause

Solution

 

 

 

The shaver does

The Jet Clean System has not

Clean the shaver thoroughly before you

not shave as well

cleaned the shaver properly because

continue shaving. If necessary, clean and

as it used to.

the cleaning fluid in the cleaning

refill the cleaning chamber (see chapter

 

chamber is soiled or the cleaning

‘Cleaning and maintenance’).

 

fluid level is too low.

 

 

The shaving heads are damaged or

Replace the shaving heads (see chapter

 

worn.

‘Replacing the shaving heads’).

 

Long hairs obstruct the shaving

Clean the shaving heads one by one (see

 

heads.

section ‘Cleaning the shaving unit with the

 

 

cleaning brush’ in chapter ‘Cleaning and

 

 

maintenance’).

The shaver does not work when I press the on/off button.

You have not inserted the shaving

Make sure that the projections of the

heads properly.

shaving heads fit exactly into the recesses

 

(see section ‘Cleaning the shaving unit with

 

the cleaning brush’).

The rechargeable battery is empty.

Recharge the battery (see chapter

 

‘Charging’) or connect the shaver to the

 

mains.

The shaver is not entirely clean after I clean it in the Jet Clean System.

The temperature of the shaver is too high. In this case, the shaver does not work.

The cleaning fluid in the cleaning chamber is soiled.

37

As soon as the temperature of the shaver has dropped sufficiently, you can switch on the shaver again.

Empty and rinse the cleaning chamber (see section ‘Cleaning the shaving unit in the Jet Clean System’ in chapter ‘Cleaning and maintenance’).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PT729CC_A6_CS3.indd 37

 

 

13.4.26 2:47:22 PM

Page 38
Image 38
Philips pt729cc manual Guarantee and support, Guarantee restrictions, Troubleshooting