Philips SBC SC 367 manual Operation fig Transmitter, Receiver

SBC367page 5

3. POWER SUPPLY

Notes

–Both the transmitter and receiver have a ‘battery low’ indication. If the batteries are low the unit beeps and the red POWER LED starts flashing.

–To conserve batteries, connect the units to the mains by using the enclosed mains adapters.

–If batteries are installed and the mains power adapters are connected, the units operate on mains power. In the event of a mains failure, the batteries will take over.

IMPORTANT

–Replace batteriesinside the transmitter with original PHILIPS LR6 POWERLIFE batteries only.

–Batteries inside the receiver are already installed. Replace these batteries with rechargeable NICAD (R6) batteries ONLY.

DO NOT INSTALL ANY OTHER TYPE OF BATTERIES INSIDE THE RECEIVER!

English

OPERATION (fig. 4)

Transmitter

•Make sure the mains power adapter is connected correctly, or batteries are installed.

•Place the transmitter near the baby’s bed, making sure that the microphone is placed in the best position for picking up baby’s sounds.

IMPORTANT!

Make sure that the transmitter is always out of reach of the baby; never place the transmitter inside baby’s bed or playpen!

•Select the VOICE mode using the mode switch (fig. 1.6).

–If sound is picked up by the built-in microphone, the transmitter starts transmitting automatically. The transmission stops when no sound is picked up any more. During transmission the green TRANSMIT LED lights up.

–The transmitter also has a button for manual transmission TALK (fig. 1.8). This function operates both during VOICE and OFF-mode. For manual transmission:

•Keep the TALK button pressed and speak into the microphone.

–The green TRANSMIT LED light up.

–Spoken sound is transmitted until the TALK button is released.

4. OPERATION

Receiver

•Make sure that the mains power adapter is correctly connected to the recharging base, or that batteries are installed.

–If batteries are installed, the receiver uses rechargeable battery power only in the event of a mains failure, or when the unit is not placed inside the standing base.

•Place the receiver inside the recharging base, near to the parent’s location.

–If the mains power adapter is connected correctly, the red CHARGE LED on the recharging base lights up.

•Switch the receiver on to an acceptable sound level (fig. 1.4).

–If a sound signal is received from the transmitter, it is heard via the built-in speaker.

• Adjust the sound level as required.

Notes

–For baby monitoring make sure the transmitter is in VOICE mode!

–Do not place transmitter and receiver too close to each other while operating. Otherwise the units will start resonating (giving a high-pitch sound).

5