18ENGLISH
7 Press the safety ring fully onto the skin with slight pressure.
Note:The safety ring has contact switches that together are the safety system of the appliance.This safety ring prevents unintentional flashing without skin contact.
,, The ‘ready to flash’ light on the back of the appliance lights up green when all contact switches of the safety ring are in contact with the skin and the device is charged. This may take up to 3.5 seconds.
Tip: For easier use, stretch the area of skin you want to treat. On areas with softer skin, you may need to exert more pressure on the appliance to push in all contact switches.
8Press the flash button to release a flash.
Note:The visible light produced by the appliance is the reflection of the flash on the skin and is harmless to your eyes. It is not necessary to wear goggles during use.
9Let go of the flash button after the appliance has flashed.
10 For the next flash, repeat steps 6 to 9.After each flash it takes up to 3.5 seconds until the appliance is ready to flash again.
Do not treat exactly the same area multiple times during one session. This does not improve the effectiveness of the treatment, but increases the risk of skin reactions.
11
12
13
To avoid untreated areas, always make sure there is some overlap with the previously treated area when you place the appliance on the skin.The effective light only comes out of the light exit window. Make sure the flashes are produced close to each other.
Switch off the appliance after you have finished the treatment.
Check the light exit window and the attachment for hairs and dirt and clean the appliance after use (see chapter ‘Cleaning and maintenance’).
