Philips SC367 warranty Baby unit, Parent unit, Congratulations, Getting the Units Ready for USE

CONGRATULATIONS

You have just purchased a high-performance, cordless Baby Monitor that lets you listen to your child from wherever you are in and around the house. You can also use the monitor to comfort your baby with the talk-back function or as a two-way intercom. Please read this guide carefully before using the monitor, and keep it for future reference.

IMPORTANT!

This Baby Monitor is intended as an aid. It is not a substitute for responsible and proper adult

supervision and should not be used as such.

Make sure the Baby unit and adapter cable are always out of reach of the baby, at least 1 metre away.

Never place the Baby unit inside the baby’s bed or playpen!

The antennas on the Parent and Baby units are fixed; do not try to extend them.

Never cover the Baby unit (with a towel, blanket, etc.)

GETTING THE UNITS READY FOR USE

Baby unit

Connect the AC power adapter (1-11) to an AC mains socket, and then connect the cord to the DC power supply socket (1-7) of the Baby unit.

If you want to use batteries, remove the battery compartment cover (1-10) using a screwdriver. Insert four 1.5V, AA batteries (not included; we recommend non-chargeable Philips Alkaline batteries), noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw.

The Baby unit operates cordlessly for up to 30 hours on fresh batteries. The red POWER light (1-2) flashes when battery power is low. If this happens install new batteries.

Note: To switch off the Baby unit completely set the mode switch (1-8) to OFF.

Parent unit

The Parent unit uses rechargeable batteries. These are already installed, but first they must be charged for at least 14 hours as follows before using the unit outside the charging base:

•Connect the AC power adapter (2-13) to an AC mains socket, and then connect the cord to the DC power supply socket (2-12) of the charging base (2-7).

•Place the Parent unit inside the charging base. The red charging light (2-15) lights.

The Parent unit can be operated now but you should leave it in the charging base until the batteries are fully charged (at least 14 hours). When the batteries are fully charged, take the Parent unit out of the charging base and use cordlessly for up to 12 hours.

When the red POWER light (2-2) on the Parent unit flashes, the battery power is low. Place the Parent unit inside the charging base to recharge the batteries.

If the rechargeable batteries begin to lose their effectiveness, replace them with four new batteries (1.2V, AA NiMH) as follows: remove the battery compartment cover (2-8) using a screwdriver and insert the batteries noting the + and - configuration inside the battery compartment. Put the cover back in place and tighten screw. Only use 1.2V, AA NiMH rechargeable batteries!

3