EN
11
Switching on the units
1Set the camera unit OFF/ON/ switch (A-4) to the ON
position.
> The POWER light (A-10) lights up green.
> The IR LEDs (A-1) are automatically activated so the
camera can also be used in low light conditions.Images are
then displayed in black and white.
2Set the monitor unit ON/OFF switch (B-8) to the ON
position.
> The POWER light (B-1) lights up green.
> You will now hear sound from the loudspeaker (B-4) and
see picture on the display (B-2).
> The sound level lights (B-3) light up when sound is picked
up by the camera unit.The more sound is picked up,the
more lights light up.
•Adjust the volume with the VOLUME control (B-8)
•If there is interference or if sound reception is poor,try
repositioning the units (camera unit first) or set both units to
another channel.See ‘Channel selection’.
Make sure that both units are always set to the same
channel.
Mode selection (Monitor unit)
The various modes are selected with the mode selection switch
(B-6) at the bottom of the monitor unit.
AV (Audio Video) mode
Sound and picture are transmitted together continuously.
Audio mode
Only sound is transmitted.No picture is shown on the display
(B-2).The baby cam is now used as a a regular baby monitor.
This saves battery power.
Auto mode
Only when sound is detected by the camera unit,sound and
picture are transmitted together and picture is shown on the
display (B-2).
When no sound is detected,no picture is shown.This saves
battery power.
Using your baby cam