Philips SCD588/54 user manual EN Preparing your baby monitor, Parent unit

EN Preparing your baby monitor

Parent unit

1Open the battery compartment by sliding the cover (B-11)

downwards.

+

+

+

+

2Insert the two 1.2V AAA size Ni-MH rechargeable batteries (supplied), noting the + and – configuration inside the battery compartment.

3Put the battery compartment cover (B-11) back in place. Close the compartment by sliding the cover (B-11) upward until it clicks in position.

4Connect the AC power adapter (B-13) of the charging base (B-14) to a wall outlet.

5Place the parent unit in the charging base (B-14).

>The POWER light (B-15) lights up red.

6Leave the parent unit in the charging base until the batteries are fully charged (at least 16 hours).

>The POWER light (B-15) will stay red, even when batteries are fully charged.

>When the batteries are fully charged, the parent unit can be taken out of the charging base and used cordlessly for at least 8 hours.

Notes:

–Operation time will be 8 hours based on the assumption that the baby unit will be transmitting 25% of the time and is in standby mode for the rest of the time (baby does not any make sound).

–When the parent unit batteries are charged for the first time, operating time will be less than 8 hours.The batteries will use their maximum capacity after at least four times charging and discharging.

10