3.2Connect receiver
Preparation
-Switch on the transmitter (A).
-Switch on the Video source.
-Take these items:
Receiver (B)
Power adapter (C)
Remote control of the video source.
- Go to TV2.
1.Connect the receiver to the second TV (TV2)
Plug the SCART cable of the receiver
(B) into the SCART port of TV2.
2. Connect the power adapter a. Take the supplied power
adapter (C) to plug the connector into the DC 9V power connector on the Receiver (B).
b. Plug the adapter into the power outlet.
1010EN
c. The green LED on the front panel should be on.
Note: if it is not the case, press the ON/OFF switch on the back of the product.
3.Set the CHANNEL switch to the same number that on the transmitter (A).
3.3Enjoy
All the operations listed on 3.1 and 3.2 should have been done.
1.Switch on TV2.
2.Switch on the receiver (B).
3.Select the correct SCART input on TV2.
4.Point the remote control of the video source to the receiver (B).
5.Operate the video source with its remote control.
6.Check if TV2 shows the image of the video source.
> The receiver is connected correctly.
Getting started
