Philips SVZ142 owner manual Turning on Your VCR, 2Turn on the TV

SVZ142.comb 4/7/99 6:30 PM Page 11

●Before turning on your VCR, make sure there are batteries in the remote control and the VCR and TV are connected (see pages five - 10).

●You can not set up channels if you are using a Cable Box/DBS.

●The instructions on this page only work when you turn on the VCR for the first time. If there is a power failure or if the VCR is unplugged for more than one minute, you may need to repeat the instructions on this page.

Turning on Your VCR 11

2Turn on the TV.

1

Press the POWER button. The POWER light and the VCR/TV light will appear.

2

Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The menu shown

below will appear.

LANGUAGE SELECT
→ ENGLISH	[ON]
ESPAÑOL

3

Press the PLAY button or the STOP button to select ENGLISH or ESPAÑOL. [ON] will appear beside your choice.

4

Press the F.FWD button or the MENU button. TUNER SET UP will appear on-screen.

TUNER SET UP

5

Press the MENU button, the F.FWD button, or the REWIND button to begin automatic channel setup.

TUNER SET UP will flash on-screen. The VCR will memorize all available channels, so when you use the CHANNEL o/p buttons, you’ll only scan through channels that you receive. When channels are set up, the TV will go to the lowest channel available.

(If you try to set up channels when there is no antenna or cable connected to the VCR, programming will appear to take place. Eventually, TUNER SET UP will appear on-screen steadily, and channel programming will stop. Connect an antenna or cable to the VCR, then press the MENU button, the F.FWD button, or the REWIND button again. Channel programming will begin again.)

1

POWER VCR/TV EJECT

1 2 3

4 5 6

7 8 9 CHANNEL

	SPEED	0	+100
	SLOW	QUICK-	SEARCH
			TIME	INDEX
		FIND			4
5	MENU	DISPLAY	EXIT	COUNTER
			RESET	MEMORY
	REWIND	/ PLAY		F.FWD
	RECORD		/ STOP	PAUSE/STILL

3

Helpful Hints

•If you do not see any on-screen dis- plays when you turn on the VCR, check your hookups, then try again. If you still do not see any on-screen displays, follow the steps under “Automatic Channel Setup” on page 12 and “Language Selection” on page 16.