9EN
Follow TV (Automatic TV channelssorting)
When the automatic channel search function is
activated, the TV channels are saved in a specific
order.This may vary from the order of TV chan-
nels on the TV.
This function changes the order of TV channels
saved in the video recorder to match that of the
TV.
Make sure that the video recorder and the TV
are connected by a scart cable.
1.
1.Switch on the TV.If required, select the pro-
gramme number for the video recorder.
2.
2.Press .The main menu will appear.
3.
3.Select 'TUNER SET UP' with or
and confirm with .
4
4.
.Select 'FOLLOW TV' with or
and confirm with .
5.
5.'P:01' will appear and '01' will flash in the
video recorder display.
6.
6.Select programme number '1' on the TV.
7.
7.Confirm with on the video
recorder remote control.The video recorder
compares the TV channels on the TV and the
video recorder.
If the video recorder finds the same TV chan-
nel as on the TV, then it stores it at 'P01'.
8.
8.Wait until the next number, e.g.'P:02' appears
in the display.
9.
9.Select the next programme number on the
TV, e.g.'2'.
10.
10.Confirm with .
11.
11.Repeat steps 8 to 10 until you have assigned
a programme number to all TV channels.
12.
12.To end, press .
Automatic Tuning
During installation, all available TV channels are
searched for and saved.If the channel assign-
ments of your cable or satellite TV provider
change or if you are re-installing the video
recorder, e.g.after moving house, you can start
this procedure again.This will replace all the TV
channels already saved with the new ones.
1.
1.Switch on the TV.If required, select the pro-
gramme number for the video recorder.
2.
2.Press .The main menu will appear.
3.
3.Select 'TUNER SET UP' with or
and confirm with .
4.
4.Select 'AUTO TUNING' with or
and confirm with .
FWD1- BSTOPC-L
PLAYB-K
FWD1- BSTOPC-L
PLAYB-K
MENU
STATUS/EXIT
FWD1- B
FWD1- B
FWD1- BSTOPC-L
PLAYB-K
FWD1- BSTOPC-L
PLAYB-K
MENU
SELECT KLCHOOSE B
AUTO TUNING
MANUAL TUNING
→FOLLOW TV
MOVE
END=EXIT
I cannot switch my TV to programme
number '1'
If you have connected additional devices to
socket AV2(DECODER), please disconnect
these devices.Because of other connected
devices, the TV could switch to the pro-
gramme number of the scart socket.
'NO TV SIGNALS' appears in the TV screen.
The video recorder is not receiving a video sig-
nal from the TV.
Check the plug on the scart cable.
Check your TV’s operating instructions to see
which scart socket is used for video signals.
If this does not help, it’s not possible to use this
function.Please read the section 'Sorting TV
channels manually'.
PLEASE WAIT
START FINISH
❚❚❚❚❚❚❚❚❚❚❚
❚❚❚❚❚❚❚❚❚❚❚❚
HG494/498ED.qx3 03.12.22 9:52 PM Page 9