Philips VRX360AT owner manual Timer Recording With the VCR Plus+ Programming System

36 Timer Recording With the VCR Plus+ Programming System

Follow the steps below to program a timer recording using the PlusCode programming numbers in your TV guide. Before you begin, make sure:

●Channels are programmed (page 12).

●The VCR Plus+ and Cable/TV channel numbers are entered (pages 34-35).

●The clock is set (page 15).

●There is a tape in the VCR. Make sure the tape’s record tab is intact and the tape is long enough to record the program(s).

●The VCR light appears on the display panel of the VCR. If it does not, press the VCR/TV button once.

Complete each step within 60 seconds of completing the previous step. If you don’t, you may return to step 1.

1

Press the VCR button, then the VCR PLUS+/ENTER but- ton on the remote control. The on-screen display shown below will appear.

VCR PLUS+ PROG.

PLUS CODE : – – – – – – – –

2

1

	3
	VCR	TV	CABLE
POWER			/DSS
	2	3	VCR/TV
1
4	5	6
			CHANNEL
7	8	9
VCR PLUS+
/ENTER

0+100

SPEED TIME SEARCH MUTE VOLUME

	PLAY
– REW			F.FWD +
	STOP
REC/OTR	MEMORY	SLOW	PAUSE/STILL
MENU	STATUS/EXIT	CLEAR	EJECT

TO END PUSH EXIT

2

Use the Number buttons to enter the PlusCode program- ming number of the program you wish to record (this number is different for every program, and it can be four to eight digits long).

Finally, press the VCR PLUS+/ENTER button.

VCR PLUS+ PROG.

PLUS CODE : 13285 – – –

TO SET PUSH VCR +

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

3

To record the program once, press the Number 1 button to select ONCE. To record the same program every day from Monday through Friday, press the Number 2 button to select DAILY. To record the same program every week on the same day (such as every Saturday), press the Number 3 button to select WEEKLY.

VCR PLUS+ PROG.

1ONCE

2DAILY

3WEEKLY

TO SELECT PUSH NO. SHOWN

TO END PUSH EXIT

Helpful Hints

•ALL PROGRAMS IN USE will appear on-screen at step 1 if all timer recording slots are full. See page 33 to clear a timer recording slot.

•If CODE ERROR flashes after you enter the PlusCode programming number and press the VCR PLUS+/ENTER button, the number you entered was incorrect or too short. If this happens, enter the cor- rect number.

•CLASH may flash on the screen at step 2 or at step 5. This means that the timer recording you just pro- grammed and another timer record- ing overlap, and thus the current timer recording will not be carried out.

•If the end of the tape is reached during a timer recording, recording will stop. The VCR will eject the tape and turn itself off.