Troubleshooting
Stations react when you operate Center’s remote control
“x” flashes on the sychro display of Center’s remote control
After the set is switched on, nothing appears on the sychronous display of Center’s remote control
The remote control does not function properly.
CD
“No Disc”/ “Cannot read CD” is displayed
Sound cannot be heard or is of poor quality.
The disc skips tracks
Sound skips during MP3/WMA playback
✔Center’s remote control is powerful enough to operate several Stations within certain distance or angle. Check you have placed the Stations in different rooms or place Stations in different angles
✔Use Station’s remote control or the controls on the set.
✔Signal error. Check you have pointed the remote control toward the IR area of the set you wish to operate
✔You switched on the set by using the control on the set instead of center’s remote control. Press REFRESH on center’s remote control to synchronize its display.
✔Remove the protective plastic tab before using the Station’s remote control.
✔Reduce the distance between the remote control and the set.
✔Insert the batteries with their polarities (+/– signs) aligned as indicated.
✔Replace the batteries.
✔Point the remote control directly towards the IR sensor.
✔Insert a suitable disc.
✔Check if the disc is inserted with graphics facing front
✔Wait until the moisture condensation at the lens has cleared.
✔Replace or clean the disc, see “Maintenance”.
✔Use a finalized
✔Adjust the volume.
✔Disconnect the headphones.
✔Switch off MUTE.
✔Replace or clean disc
✔Switch off SHUFFLE
✔MP3 file made at compression level exceeding 320kbps. Use a lower compression level to rip audio CD tracks.
✔Replace or clean disc.
English
47