Philips WV-NM100 operating instructions Using via the Internet Connection type, Required hardware

CONNECTIONS

Using via the Internet (Connection type 3-4)

Connecting the camera to the Internet using an xDSL modem or a cable modem.

< Connection example >

Internet

Internet

Cable modem	Connection of
	a single camera
Cable line	To an outlet
	(230 V AC)
	AC adapter

Broadband router

Cable modem or xDSL modem (1 port)

To an outlet (230 V AC)

Cable line	AC adapter
or xDSL
line

To an outlet (230 V AC)

AC adapter

Connection type 3

Connection type 4

<Required hardware >

•Cable modem or xDSL modem

•Broadband router

<Required cable >

Ethernet cable (category 5 straight cable)

!Important

•When the camera is connected using connection type 3 or 4, obtain the global IP address from the Internet ser- vice provider. Perform the settings of the camera by connecting the camera and the PC directly. (Refer to the next page.)

•When the camera is connected using connection type 3, it is required to assign the global IP address to the cam- era. When the camera is connected using connection type 4, it is required to assign the global IP address to the broadband router and to set the address translation. (Refer to page 26.).

•Use an Ethernet switching hub or a broadband router suitable for 10Base-T/100Base-TX. Install also a LAN card suitable for 10Base-T/100Base-TX on the PC.

•All cameras connected to the network must use their own exclusive AC adapter.

•To use multiple cameras, it is necessary to set up the router and assign each camera with an HTTP port number. For further information about the assignment of the HTTP port number to the camera, refer to page 28. For fur- ther information about the setup of the router, refer to the operating instructions of the router.

14