Pico Macom CAM-35UNIV I N S T A L L A T I O N, Installation Procedures, Electrical Connection

I N S T A L L A T I O N

Installation Procedures

1.Electrical Connection:

Plug the power cord into 120 Vac, 60Hz electrical outlet.

2.Video and Audio Input Connections:

a.Slide the rear display switch to the ON position. This switch activates and deactivates the digital display and the channel selector but- tons on the front panel.

b.Connect in the audio and video plugs from the input source to the AUDIO in and VIDEO in jacks respectivily. For sources with only one audio output, connect to either the right or left jack.

c.Using the two front panel controls, select a channel between 14 and 69 for off-air or 37 to 125 for CATV. NOTE: The modulator's LED displays either off-air UHF or cable (CATV) channels.

d.After selecting the channel, slide the rear display switch, on rear panel, to the OFF posi- tion. This will disable the front panel tuning controls and turn off the LED display. The channel you have selected will be stored in memory.

3.RF Output Connections:

The CAM-35UNIVan be used for various applications to modulate a signal source such as a satellite receiver, VCR, laser disk player,

camcorder or surveillance camera to an ultraband CATV channel or a standard UHF channel.

4.Channel Selection Guidelines:

a.The CAM-35UNIVmodulator converts your input source to either UHF or Cable (CATV)

channels. Be sure your television set is tuned properly for off-air or cable reception.

b.Do not select channels that are adjacent to a CATV or an active off-air channel. In applica- tions using multiple modulators, do not set mod- ulators to adjacent channels, for example 20, 21, 22.

c.Do not select a channel on which a local TV channel is being broadcast.

d.Caution: The lowest UHF frequencies, chan- nels 14-19, have also been assigned as a commer- cial communications band. A nearby transmit- ter could cause intermittent interference on these channels.

5.Completion:

Once connections have been make and the de- sired channel has been selected, installation of the CAM-35UNIVis complete.

TO DISTRIBUTION SYSTEM

AC120V
60Hz				AUDIO IN		VIDEO	RF
15W		DISPLAY
		OFF ON	R	L/B.B.	L	IN	OUT
						B.B.
	CAM-35UNIV
							FROM LNB
			VIDEO OUT
AUDIO OUT		VIDEO			COMPOSITE		LNB
R	L	OUT			VIDEO OUT		IN
							SATELLITE RECEIVER

LEFT , RIGHT AUDIO OUT

5

Note: If mono receiver is used, audio may be connected to either audio jack on CAM-35UNIV

PICO MACOM INC. 12500 Foothill Blvd., Lakeview Terrace, CA 91342 • (818) 897-0028 • (800) 421-6511 • FAX (818) 834-7197