Pioneer DEH-1200MP Operating this unit Use and care of the remote control, Basic Operations

	Section
Operating this unit	02

Use and care of the remote control

Using the remote control

1Point the remote control in the direction of the front panel to operate.

When using for the first time, pull out the film protruding from the tray.

Replacing the battery

1Slide the tray out on the back of the remote con- trol.

2Insert the battery with the plus (+) and minus (–) poles aligned properly.

Important

!Do not store the remote control in high tem- peratures or direct sunlight.

!The remote control may not function properly in direct sunlight.

!Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal.

WARNING

!Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately.

!Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION

!Use one CR2025 (3 V) lithium battery.

!Remove the battery if the remote control is not used for a month or longer.

!There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

!Do not handle the battery with metallic tools.

!Do not store the battery with metallic objects.

!If the battery leaks, wipe the remote control completely clean and install a new battery.

!	When disposing of used batteries, comply	English
	with governmental regulations or environmen-
	tal public institutions’ rules that apply in your
	country/area.

! “Perchlorate Material – special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/ perchlorate. (Applicable to California, U.S.A.)”

Basic Operations

Important

!Handle gently when removing or attaching the front panel.

!Avoid subjecting the front panel to excessive shock.

!Keep the front panel out of direct sunlight and high temperatures.

!Remove any cables and devices attached to this unit before detaching the front panel to avoid damage to the device or vehicle interior.

Removing the front panel to protect your unit from theft

1Press the detach button to release the front panel.

2Grab the front panel and remove.

Re-attaching the front panel

1Slide the front panel to the left until it clicks. Front panel and the head unit are connected on the left side. Make sure that the front panel has been properly connected to the head unit.

2Press the right side of the front panel until it is firmly seated.

If you can’t attach the front panel to the head unit successfully, try again. However, forcing the front panel into place may result in damage.

Turning the unit on

1Press SRC/OFF to turn the unit on.

En 5