Section
03 
Installation
Connections
WARNING
!Use speakers over 50 W (output value) and be- tween 4 W to 8 W (impedance value). Do not use 1 W to 3 W speakers for this unit.
!The black cable is ground. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car’s body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire, generation of smoke or malfunction.
Ground wire | POWER AMP | ||
|
|
|
|
|
|
|
|
Other devices | Metal parts of car’s body | |
(Another electronic | ||
| ||
device in the car) |
|
Important
!When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain.
| F | ON | ||
| F |
|
|
|
| O |
|
| S |
|
|
|
| T |
|
|
| R | A |
|
| T |
| |
ACC position | No ACC position | |||
!Use this unit with a
!To prevent a
—Disconnect the negative terminal of the battery before installation.
—Secure the wiring with cable clamps or ad- hesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring.
—Place all cables away from moving parts, such as the gear shift and seat rails.
—Place all cables away from hot places, such as near the heater outlet.
—Do not connect the yellow cable to the bat- tery by passing it through the hole to the engine compartment.
—Cover any disconnected cable connectors with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited.
—Use a fuse of the rating prescribed.
—Never wire the negative speaker cable di- rectly to ground.
—Never band together negative cables of multiple speakers.
!When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an exter- nal power amp or the vehicle’s
!Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect it to the power terminal of the auto antenna. Doing so may result in bat- tery drain or a malfunction.
Installation
This unit
1 | 2 3 | 4 |
1Antenna input
2Fuse (10 A)
3Power cord input
4Rear output
Power cord
L 
1 R
23
4 |
|
|
| |
|
| 6 |
|
|
|
| 8 |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
F |
|
|
|
|
| 7 |
|
|
|
| 9 |
|
|
| |
|
|
|
|
|
|
|
|
| | ||||||
5 |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
| |
|
| a |
|
|
|
| c |
|
| | |
|
|
|
|
|
|
|
|
|
|
|
|
| |||
R |
|
|
|
|
|
| b |
|
|
|
| d |
|
| |
| |
|
|
|
|
|
|
| | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
e
f g h
1To power cord input
2Left
3Right
4Front speaker
5Rear speaker
6White
7White/black
8Gray
9Gray/black
aGreen
bGreen/black
cViolet
dViolet/black
eBlack (chassis ground)
Connect to a clean,
fYellow
Connect to the constant 12 V supply terminal.
Section
03
g | Red | English |
| ||
| Connect to terminal controlled by ignition |
|
| switch (12 V DC). |
|
h Blue/white
Connect to system control terminal of the power amp or
Note
With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers.
Power amp (sold separately)
Perform these connections when using the optional amplifier.
1
| 2 |
|
|
| | 3 | 4 |
|
| ||
5 |
| 5 |
|
| |
|
|
1System remote control Connect to Blue/white cable.
2Power amp (sold separately)
3Connect with RCA cables (sold separately)
4To Rear output
5Rear speaker
Installation
Important
! Check all connections and systems before final installation.
! Do not use unauthorized parts as this may cause malfunctions.
! Consult your dealer if installation requires drilling of holes or other modifications to the vehi- cle.
! Do not install this unit where:
— it may interfere with operation of the vehi- cle.
— it may cause injury to a passenger as a result of a sudden stop.
10 | En | En | 11 |