Section
03 
Installation
| Section |
Installation | 03 |
!The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.
!Optimum performance is obtained when the unit is installed at an angle of less than 60°.
60°
DIN front/rear mount
This unit can be properly installed using either
DIN Front-mount
1 Insert the mounting sleeve into the dashboard.
For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the vehicle.
2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.
1
2
1Dashboard
2Mounting sleeve
3 Install the unit as illustrated.
Use commercially available parts when instal- ling.
1
2
3
4
5
1Nut
2Firewall or metal support
3Metal strap
4Screw
5Screw (M4 × 8)
#Make sure that the unit is installed securely in place. An unstable installation may cause skip- ping or other malfunctions.
DIN Rear-mount
1Determine the appropriate position where the holes on the bracket and the side of the unit match.
2Tighten two screws on each side.
1 
3
2
1Screw
2Mounting bracket
3Dashboard or console
Use either truss (5 mm × 8 mm) or flush surface (5 mm × 9 mm) screws, depending on the bracket screw holes.
Removing the unit | Securing the front panel | English |
1 Remove the trim ring. | The front panel can be secured with the sup- | |
| plied screw. | |
| 1 |
|
1 Screw
1Trim ring
2Notched tab
!Releasing the front panel allows easier ac- cess to the trim ring.
!When reattaching the trim ring, point the side with the notched tab down.
2Insert the supplied extraction keys into both sides of the unit until they click into place.
3Pull the unit out of the dashboard.
Removing and re-attaching the front panel
You can remove the front panel to protect your unit from theft.
Press the detach button and push the front panel upward and pull it toward you.
For details, refer to Removing the front panel to protect your unit from theft and
12 | En | En | 13 |