Pioneer DEH-3050UB Initial Settings, Switching the warning tone, Switching the auxiliary setting

	Section
Initial Settings	04

3Turn MULTI-CONTROL to select the AM tuning step.

Turning MULTI-CONTROL will switch the AM tuning step between 9 kHz and 10 kHz. The se- lected AM tuning step will appear in the dis-

play.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING TONE.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.

1Use MULTI-CONTROL to select AUX.

2Press MULTI-CONTROL to turn AUX on.

# To turn AUX off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (REAR SP :FULL/

PREOUT:REAR) or subwoofer

(REAR SP :SUB W/PREOUT:SUB W) connec-

tion. If you switch the rear output setting to REAR SP :SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speak- er connection (REAR SP :FULL). When rear output is connected to full range speakers (when REAR SP :FULL is selected), you can connect the RCA subwoofer output to a sub- woofer. In this case, you can select whether to use the subwoofer controller’s (low pass filter, phase) built-in PREOUT:SUB W or the auxili- ary PREOUT:REAR.

1Use MULTI-CONTROL to select

SW CONTROL.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Press MULTI-CONTROL to select the seg- ment you wish to set.

Press MULTI-CONTROL repeatedly to switch the segment in the following order:

REAR SP (rear speaker setting)—PREOUT (RCA output setting)

4Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

When REAR SP (rear speaker setting) is se- lected.

REAR SP :SUB W (subwoofer)— REAR SP :FULL (full-range speaker)

When PREOUT (RCA output setting) is se- lected.

PREOUT:SUB W (subwoofer)—

PREOUT:REAR (full-range speaker)

# When no subwoofer is connected to the rear

output, select REAR SP :FULL.

# When a subwoofer is connected to the rear output, set for subwoofer REAR SP :SUB W.

English

En 23