Installation
Fastening the front panel
If you do not plan to detach the front panel, the front panel can be fastened with supplied screw.
Screw
Connecting the Units
Notes
•When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. Otherwise, battery drain may result.
ACC position | No ACC position |
•Use this unit in other than the following conditions could result in fire or malfunction.
–Vehicles with a
–Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value).
•To prevent
–Disconnect the negative terminal of the battery before installation.
–Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.
–Place all cables away from moving parts, such as gear shift and seat rails.
–Place all cables away from hot places, such as near the heater outlet.
–Do not pass the yellow cable through a hole into the engine compartment to connect to a battery.
–Cover any disconnected cable connectors with insulating tape.
–Do not shorten any cables.
–Never cut the insulation of the power cable of this unit in order to share the power to other equipment. Current capacity of the cable is limited.
–Use a fuse of the rating prescribed.
–Never wire the speaker negative cable directly to ground.
–Never band together multiple speaker’s negative cables.
•Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp’s system remote control or the vehicle’s
•Never connect blue/white cable to external power amp’s power terminal. Also, never connect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result.
•Black cable is ground. This cable and other product’s ground cable (especially,
•Cord function may differ according to the product, even if cord color is the same. When connecting this system, be sure to check all manuals and connect cords correctly.
4
ENGLISH
