![Depending on the kind of vehicle, the](/images/new-backgrounds/29970/299709x1.webp)
Connecting the Units
Note |
|
Depending on the kind of vehicle, the |
|
function of 3* and 5* may be different. In this |
|
case, be sure to connect 2* to 5* and 4* to 3*. |
|
This product |
|
Rear output |
|
Antenna jack | Fuse |
| |
Connect leads of the same | (10 A) |
| |
color to each other. |
|
Cap (1*)
Do not remove cap if this terminal is not in use.
Connect with RCA cables (sold separately)
Wired remote input
Blue/white
Connect to system control terminal of the power amp (max. 300 mA 12 V DC).
Blue/white (7*)
Connect to
Power amp (sold separately)
System remote control
Yellow (3*)
Red (5*) Accessory (or back- up)
Yellow (2*)
Connect to the constant 12 V supply terminal.
Red (4*)
Connect to terminal controlled by ignition swich (12 V DC).
Blue/white (6*)
The pin position of the ISO connector will differ depends on the type of vehicle. Connect 6* and 7* when Pin 5 is an antenna control type. In another type of vehicle, never connect 6* and 7*.
Left | Right |
Black (chassis ground)
Connect to a clean,
ISO connector | Yellow/black |
Note | If you use an equipment with Mute |
In some vehicles, the ISO connector may | function, wire this lead to the Audio |
be divided into two. In this case, be sure | Mute lead on that equipment. If not, |
to connect to both connectors. | keep the Audio Mute lead free of any |
| connections. |
Rear Speaker Rear Speaker
Perform these connections when using the optional amplifier.
Speaker leads | Front left + |
White: | |
White/black: | Front left - |
Gray: | Front right + |
Gray/black: | Front right - |
Green: | Rear left + |
Green/black: | Rear left - |
Violet: | Rear right + |
Violet/black: | Rear right - |
ENGLISH
5