Pioneer DEH-P6300, DEH-P7300 Setting the Rear Output and Subwoofer Controller SW

Setting the Rear Output and Subwoofer Controller (SW)

This product’s rear output (rear speaker leads output and RCA Rear output*) can be used for full-range speaker (“Rear SP:FULL”) or Subwoofer (“Rear SP:S.W”) connection. If you switch Rear Output setting to the “Rear SP:S.W”, you can connect a rear speaker lead directly to a Subwoofer without using an auxiliary amp.

Initially, the unit is set for rear full-range speaker connection (“Rear SP:FULL”).

When rear output are connected to full range speakers (when “Rear SP:FULL” is selected), you can connect the RCA Subwoofer output to a Subwoofer. In this case, you can select whether to use the Subwoofer controller’s (Low Pass Filter, Phase) built-in “S.W Control:INT” or the auxiliary “S.W Control:EXT”.

* DEH-P6300 doesn’t have RCA Rear output.

Note:

•Even if you change this setting, there is no output unless you switch the Non Fading Output (refer to page 38) or Subwoofer Output (refer to page 37) in the Audio Menu ON.

•If you change the Subwoofer Controller, Subwoofer output and Non Fading output in the Audio Menu return to the factory settings.

•Both rear speaker leads output and RCA Rear output* are switched simultaneously in this setting mode. (* DEH-P6300 doesn’t have RCA Rear output.)

1.Press the FUNCTION button and select the Rear Output and Subwoofer Controller setting mode (SW) in the Initial Setting Menu.

2.Change the Rear Output set-

ting with the 5/∞ buttons.

Note:

•When no Subwoofer is connected to the rear output, select “Rear SP:FULL”.

•When a Subwoofer is connected to the rear output, set for Subwoofer “Rear SP:S.W”.

•When the Rear Output setting is “Rear SP:S.W”, you cannot change the Subwoofer controller.

3.Change the Subwoofer

Controller with the 2/3 but- tons.

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS

44