Pioneer DEH-P7950UB Resetting the microprocessor, About the demo mode, Attaching the front panel

	Black plate (7,1)
	Section
Before You Start	01

Attaching the front panel

1Make sure the inner cover is closed.

2Replace the front panel by clipping it into place.

Resetting the microprocessor

The microprocessor must be reset under the following conditions:

!Prior to using this unit for the first time after installation

!If the unit fails to operate properly

!When strange or incorrect messages ap- pear on the display

%Press RESET with a pen tip or other pointed instrument.

Important

The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.

Reverse mode

If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode.

Feature demo mode

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power.

English

RESET button

About the demo mode

This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.

En 7

<CRD4164-A/N>7