Mixer section

1 1

 

a

 

2

 

2

 

b

 

3

c

3

4

6

4

 

 

7

55 9

8

1TRIM control

2EQ (HI, MID, LOW) controls

3FILTER control

4Headphones CUE/TAP button

5Channel fader

6Level indicator switch

7Level indicator

8Crossfader

9CROSS FADER REVERSE indicator a MASTER LEVEL control

b HEADPHONES MIX control c SAMPLER VOLUME control

Effect section

This section is used to control the two effect units (FX1 and FX2). Controls and buttons to operate the FX1 unit are located on the left side of the controller, those to operate the FX2 unit are located on the right side of the controller.

1 2 3 4 5 6

7 8 9 a

1FX ASSIGN 1 buttons

2FX ASSIGN 2 buttons

3Effect parameter 1 control

4Effect parameter 2 control

5Effect parameter 3 control

6FX BEATS control

7Effect parameter 1 button

8Effect parameter 2 button

9Effect parameter 3 button a TAP (FX MODE) button

Front panel

English

 

 

 

1

2

3

4

1HEADPHONES LEVEL control

2CROSS FADER REVERSE switch

3CROSS FADER CURVE control

4MIC LEVEL control

Rear panel

1

2

3

4

1AUX IN LEVEL control

2BOOTH LEVEL control

3BOOTH/MASTER selector switch

4ON/OFF switch

About the controls’ setting values

The setting values of the controls, etc., below are controlled individually for the respective decks in the Serato DJ software.

TRIM control

EQ (HI, MID, LOW) controls

FILTER control

Channel fader

TEMPO slider

If the values controlled by Serato DJ when the decks are switched differ from the positions of this unit’s controls, faders, etc., the controls, fad- ers, etc., must be moved to the positions corresponding to the values controlled by Serato DJ before they will operate.

The default values for decks 3 and 4 in Serato DJ are the center position for the [TRIM] controls, [EQ (HI, MID and LOW)] controls and [FILTER] controls, ±0.0% for [TEMPO] sliders, and the frontmost position for the channel faders.

En 13