Pioneer DJM-250-K, DJM-250-W, DJ Mixer section, Audio output, Audio input section, 6En, Cord hook

Connecting the input/output terminals

!When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit’s input terminals and in the settings of the input selector switches.

Also refer to the operating instructions of the DJ software and audio interface.

Rear panel, front panel

Audio input section

Example:

CDJ-350

Audio cable
RR	LL	DJ player	Analog player
AUDIO
OUT		Control cord 1
CONTROL
USB

								To ground wire	To audio output
								terminals	terminals
								Ground wire
								Audio cable
									Microphone
Rear panel								Microphone cable
								To microphone
	CH-2		SIGNAL	CH-1		AUX
	PHONO / LINE	CD		PHONO / LINE CD	3	2
			GND
ON OFF	L			LL		L
To power outlet	L				L	L	MIC
LINE	PHONO		LINE	PHONO R					Portable audio
			CONTROL		CONTROL	1
	R			R	R	R R			device
	R
DC IN	R	L	R	L		1GND
					3 COLD	2 HOT		Audio cable
AC adapter	R	L						To audio output
(included)					MASTER 1
	MASTER 2							terminals
Audio output									Computer
section								Audio cable
				Powered speaker, component,
Front panel								To audio output
					amplifier, etc.
Headphones								terminals
									synthesizer
					To audio input terminals			Audio cable
				Audio cable				To audio output
Headphones								terminals
cord				Audio cable

1To use the fader start function, connect a control cord (page 11).

The fader start function can only be used when connected to a Pioneer DJ player.

Cord hook

Loosen the cord hook’s screw and pinch the AC adapters’ power cord under the hook.

Cord hook

		R
DC IN	R	L

MASTER 2

AC adapter’ s power cord

!Place the cord hook out of reach of children. If a child should swallow it, contact a physician immediately.

6En