MREC k/g

NPLAY f

OTRACK MARK (PREVIEW)

PSEARCH o, p

Master effect section

Effects can be applied to the sound output from [MASTER OUT 1, 2] (page 12).

QMASTER EFFECT (GATE, CRUSH, JET, FILTER)

RLEVEL/DEPTH

About the power switch of this unit

To turn the power on

Press [u] 1.

Turn on the power of this unit.

The [u] indicator lights green.

To set to the standby mode

When this unit’s power is on, press [u] 1 for at least 2 seconds.

This unit is set to the standby mode.

The [u] indicator lights red.

!When [u] is pressed again, the power turns on.

!This unit is equipped with an auto standby function. For details, see About the auto standby function on page 13.

Basic operations (mixer section)

 

b

CD PHONO

CD PHONO

TRIM

TRIM

 

c

9

9

HI

HI

MASTER

CH-1

CH-2

9

9

MID

MID

d

d

9

9

LOWLOW

12

LEVEL

 

9

9

CH- 1 e

CH-2

f

 

g

h i

FADER

FADER

START

START

THRU

j

Outputting sound

Check that this unit is properly connected to the DJ player, etc., before outputting sound. For instructions on connections, see Connecting the input/output terminals on page 8.

Set the volume of the power amplifiers connected to the [MASTER OUT 1, 2] terminals to an appropriate level. Note that very loud sounds will be output if the volume is set too high.

 To output the sound of channel 1 [CH-1] 1

To output the sound of channel 2 ([CH-2]) 2, perform the procedure below replacing [CH-1] with [CH-2].

1 Switch the [CD, PHONO] (input selector) switch B for the [CH-1] 1.

Select the input source for [CH-1] from among the devices connected to this unit.

— [CD]: Selects the DJ player connected to the [CD] terminals.

— [PHONO]: Selects the analog player connected to the [PHONO] terminals.

2 Turn the [TRIM] C control for the [CH-1] 1 clockwise.

Adjusts the audio level input to the [CH-1] terminal.

The [CH-1] channel level indicator F lights when audio signals are being properly input to [CH-1].

Adjust [TRIM] so that the orange indicator lights at the point in the track where the volume is loudest (the climax, etc.).

Be careful that the red indicator does not light, or the sound could be distorted.

3 Move the [CH-1] 1 channel fader G to the back side.

The level of the sound output from the [CH-1] terminals is adjusted.

4 Switch [THRU, ,] (the crossfader curve selector switch) I.

This switches the crossfader curve characteristics.

— [THRU]: Choose this when you do not want to use the crossfader.

— []: Set here for a curve that rises gradually.

10En