Connecting up | 02 |
Watching progressive scan video from the component video outputs
This player can output progressive scan video from the component video output. Compared to interlace video, progressive scan video effectively doubles the scanning rate of the picture, resulting in a very stable,
To set up the player for use with a progressive scan TV, see Video Output settings on page 31. When the player is set to output progressive scan video, the PRGSVE indicator lights in the front panel display.
Important
•When Component Out (page 31) is set to Progressive, there is no video output from the VIDEO OUT (composite) and S (S- video) jacks.
•If you want to display video on more than one monitor simultaneously, make sure the player is set to Interlace.
•If you connect a TV that is not compatible with a progressive scan signal and switch the player to progressive, you will not be able to see any picture at all. In this case, switch everything off and reconnect using the supplied video cable (see Easy connections on page 9), then switch back to Interlace (see below).
Switching the video output to interlace using the front panel controls
Switch the player to standby then, using the front panel controls, press STANDBY/ON
while pressing | to switch the player back to |
Interlace. |
|
STANDBY/ON |
|
STANDBY/ON |
|
|
Compatibility of this player with
This player is compatible with progressive video Macro Vision System Copy Guard.
Consumers should note that not all high- definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch the connection to the ‘standard definition’ output (Interlace). If there are questions regarding our TV set compatibility with this model, please contact our customer service center.
This player is compatible with the following Pioneer displays and monitors:
Plasma display
1110HD,
Projection monitor receiver
610HD,
530HD,
11
En
