CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN
Sound Board
| Audio Cable | |
|
| |
SCSI HOST | Pin 1 |
|
Adapter |
|
|
| Pin 1 | SCSI hard disk |
SCSI Interface
Cable
Into an expansion slot of the personal computer
To the power supply of the personal computer
Fig. 4
When a SCSI hard disk or other SCSI equipment is installed in the computer, please connect according to the following method.
¶Turn off the power supply of the personal computer.
¶Set the SCSI ID number so that it is different from the ID numbers of all other SCSI units.
¶Disable internal SCSI termination (switch #5 = OFF).
¶Connect the power supply cable from the personal computer. At the time of connection, pay attention to the cable polarity. Please use a power supply cable with two or more connectors in parallel.
¶Connect the SCSI interface cable. At this time, confirm that the pin 1 of the SCSI connector is connected correctly to pin 1 of the cable. Use a cable with two or more connectors in parallel.
¶When a sound board is used, connect the audio output with an audio cable to the sound board.
WARNING
The power supply of the personal computer must be turned off before cables are connected.
10
<DRC1095> En
