![](/images/new-backgrounds/1157628/157628187x1.webp)
Internal Registers
9.EXTERNAL SWITCH CONTROL
To activate a function, create a switch contact with an electrical ground (Pin 1). Check Chapter 2 to verify pin (Pin 6 through Pin 13) and terminal (SW1 ~ SW8) assignments.
There are three SW functions in the EXTERNAL SWITCH CONTROL.
1. To recall Barcode/Command Stacks and execute
The function, STACK GROUP 1 to STACK GROUP 27, is similar to a combination of remote control buttons to recall and execute a stack.
2. To execute the function as a remote control command
The function acts the same as the buttons (ENTER, PLAY, STOP, etc.) on a remote control excluding SCAN FWD/REV.
A scan request sent through the remote control may be Paused. However, once a scan command is halted, the request is lost.
3. To execute as an advanced remote control button
Advanced remote control commands such as OPEN/CLOSE, numbers from 10 to 20, and the four slanting arrows may be sent as a switch control command.
Note for additional assistance, please refer to Product Information Bulletin (PIB) 152601
9.1Function Assignment
Create a Circuit Controller or a Diode Matrix Circuit (refer to the table below). Diode Assignment List
| SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | SW7 | SW8 |
|
|
| ↑ | ↓ | ← | → | ENTER | X | Y | Z | Function | |
| X |
|
|
|
|
|
|
| ↑* | |
|
| X |
|
|
|
|
|
| ↓* | |
|
|
| X |
|
|
|
|
| ←* | |
|
|
|
| X |
|
|
|
| →* | |
|
|
|
|
| X |
|
|
| ENTER* | |
|
|
|
|
|
| X |
|
| STACK GROUP1* | |
|
|
|
|
|
|
| X |
| STACK GROUP2* | |
|
|
|
|
|
|
|
| X | STACK GROUP3* | |
|
|
|
|
|
|
|
|
|
|
|
| X |
|
| X |
|
|
|
|
|
|
|
| X |
| X |
|
|
|
|
|
|
XX
XX
- 87