Pioneer DVD-V7400 manual Please make sure the PC-2 is powered down before attaching

Instructions on Programming - DVD4 Version 1.5

Programming Overview:

This program, designed for the Technovision PC-2 allows the following information to be programmed into the battery backed up memory of the controller:

-Start and end frames (within title 1) for up to 4 Pioneer DVD players that are played in sync upon a button press. Players not used MUST have their beginning frames programmed in as ∅∅∅∅∅∅∅.

Failure to do this will result in increased search times on the system.

Hardware Requirements:

This program requires a Pioneer DVD-V7400 with the baud speed set for 4800.

A programming remote (CUV-162) is required to use this program. This remote comes standard with the DVD-V7400 DVD player. A custom control cable (P4-CAB) is also required to control the laserdisc players.

-- CAUTION --

Please make sure the PC-2 is powered down before attaching

cables, program card and buttons.

Programming Sequence:

1.Insert program card into the PC-2 with the label facing up.

2.Attach player cable to the communications port of the PC-2 and the serial port of the players.

3.Player 1 must be connected since the program will use it’s built in character generator for prompting.

4.Attach video cables to monitors.

5.The PC-2, players and monitors should be connected to the same power source.

6.Power the system up.

7.When the “Technovision PC-2” prompt appears on the screen for player #1 you will have 8 seconds to press the ∅ (zero) button on the remote to go to the MAIN MENU. If the ∅ is not pressed the system will run the program using the data last stored within the controller

Page 3

The Main Menu will present the following options:

1. View Settings	This choice will display the
	current start and end points
	for the players
2. Change INFO	This choice will allow you to
	change the start and end
	points for the players.
3. KEYLOCK **	Will	enable/disable	the
	remote	from working	with
	the players.

4.AUTOSTART ** Changes the shows starting process.

9. RUN PROGRAM Executes the program.

View Settings:

The View Settings choice shows the current beginning and end frames for the players.

Change INFO:

By selecting this option you will be prompted to:

Enter player # (1..4)

<SEARCH/MENU> FOR MENU

After the player number is entered, the current settings will be displayed and you will be prompted to enter the new settings. You must enter all 7 digits for the start and end frames. Pressing the CLEAR will erase the current entry. Pressing SEARCH or MENU on the remote will return you to the “Enter Player MENU”.

If a player is not to be used, the beginning point has to be entered as

∅∅∅∅∅∅∅.

Page 4