06Recording

1 Press ‘VCR Plus+’.

The front panel display shows the current recording mode and prompts you to enter the PlusCode number.

P L US CODE

2Use the number buttons to enter the PlusCode number.

2 9 32 4

• To clear the last digit entered, press CLEAR.

3 Press ENTER.

The display shows the timer settings:

Date Start time End time Recording medium (DVD or HDD) and Recording channel.

If CODE ERROR appears in the display, check that the PlusCode number is correct and start again from step 1.

If CAN’T SET appears in the display, it means that although you entered a valid PlusCode number, the program has already finished.

Stopping or extending a timer recording in progress

After a timer recording has started, you can cancel or extend recording.

REC STOPREC

1 Press and hold REC for 3 seconds.

Only the program is canceled (the timer indicator disappears); recording continues.

2If you want to stop recording completely, press

STOP REC.

• To extend recording, press REC repeatedly to extend recording in 30 minute increments.

Preventing use of the recorder before a timer recording (child lock)

You can make all the front panel and remote control buttons inoperative using the child lock feature. This is useful when you set a timer recording and want to make sure that the timer settings are not changed before recording has finished.

1 If the recorder is on, switch it into standby.

2 Press and hold STOP on the front panel for 3 seconds to lock the controls.

The front panel display briefly shows LOCK. If any buttons are pressed on the remote or front panel, LOCK is briefly displayed again.

• To unlock the recorder, press and hold STOP on the front panel for 3 seconds until the display shows

UNLOCK.

To cancel a timer recording when the recorder is locked, first unlock the recorder (see above), then press and hold REC for 3 seconds.

Timer recording FAQ

Frequently Asked Questions

Even though the timer is set, the recorder doesn’t start recording!

Check that the disc loaded or HDD is recordable, not locked (see Lock Disc on page 84), and that there are fewer than 99 titles already on the DVD/HDD.

The recorder won’t let me enter a timer program! Why not?

You can’t enter a timer program while a timer recording is in progress, during timer recording standby or when the clock isn’t set.

What happens when two or more timer programs overlap?

Basically, the program with the earlier recording start time has priority. However, the recorder will start recording the program with the later start time after the earlier program is finished. If two programs have the same times (but different channels, for example), the program set most recently takes priority.

I entered a timer program, but the recorder doesn’t confirm whether or not it’s OK. Why not?

Timer confirmation only works for DVD recordings when there is a recordable disc loaded, and it is not currently recording. Also make sure that the disc is not locked (see Lock Disc on page 84) and that there are fewer than 99 titles already recorded. Note that it’s possible that although the timer recording screen says OK, the recording doesn’t complete successfully because of some other reason, such as a damaged disc, etc.

50

En

Page 50
Image 50
Pioneer DVR-510H manual Timer recording FAQ, US Code, Stopping or extending a timer recording in progress, Unlock