Recording 05
41
En
G-Code programming with the power off
You can enter a G-Code programming
number when the recorder is in standby.
Note that the recording is always made to
the HDD. If you want to record to a DVD disc,
you’ll need to switch on the power and use
the full G-Code program screen.
Important
•You can’t use this feature until you have
set up the guide channels. See
G-Code
CH Setting
on page 107.
• You can’t change the recording mode.
• You can’t program daily or weekly timer
recordings.
1 Press ’G-Code’.
The front panel display shows the current
recording mode and prompts you to enter
the G-Code programming number.
2Use the number buttons to enter the
number.
• To clear the last digit entered, press
CLEAR
.
3Press ENTER.
The display shows the timer settings:
Date
Start time
End time
HDD and
Recording channel
Recording mode.
• If
CODE ERROR
appears in the display,
check that the number is correct and
that the guide channel is set (see
G-Code
CH Setting
on page 107), then set the
timer recording again.
• If
CAN’T SET
appears in the display, it
means that although you entered a valid
number, the program has already
finished.
Setting a manual timer recording
The timer recording screen you can see all
the timer programs already set, clear
programs and set up new ones.
1Press TIMER REC to display the Timer
Recording screen.
You can also access the Timer Recording
screen from the Home Menu (press
HOME
MENU
, select
Timer Recording
, then
Timer
Recording
).
This screen shows all the timer programs
currently set.
• Each row is for one timer recording
program, with the date and time
information, channel, recording mode,
DVD or HDD and recording status.
• The amount of free space available on
the HDD and the currently loaded
recordable DVD is shown towards the
bottom of the screen.
•In the upper-right corner, the number of
timer programs already set is shown
next to
Tmr Pgms
.
• If there are more than five timer
programs already set, press
NEXT
to switch page (go back using the
PREV
button).
• You can also delete a timer program
before it’s started (before the recorder
enters timer recording standby) by
highlighting it and pressing
CLEAR
. See
also
Deleting a timer program
on
page 43.
HDD Remain
DVD Remain
59h59m(SP)
1h59m(SP)
3/26 SUN 3:00PM
Tmr Pgms 3/32
Manhattan Open Tennis OK
3/26 SUN 6:00PM – 7:00PM 10ch
World Journey OK
3/27 MON 7:30PM – 9:00PM 4ch
8ch
Flower Until 4/20
MON – FRI 1:30PM – 2:00PM
New Input
Timer Program View
DVR745H_IBD_EN.book 41 ページ ２００６年７月２７日　木曜日　午後４時１１分