Pioneer GM-6200F owner manual Specifications

Specifications <ENGLISH>

Power source	14.4 V DC (10.8 — 15.1 V allowable)
Grounding system	Negative type
Current consumption	35.0 A (at continuous power, 4 Ω)
Average current drawn*	9.0 A (4 Ω for four channels)
	15.0 A (4 Ω for two channels)
Fuse	25 A ⋅ 2
Dimensions	300 (W) ⋅ 61 (H) ⋅ 336 (D) mm
	[12 in. (W) ⋅ 2-3/8 in. (H) ⋅ 1 ft. 1 in. (D)]
Weight	3.9 kg (8.6 lbs.) (Leads for wiring not included)
Maximum power output	120 W ⋅ 4 ( 4 Ω) / 300 W ⋅ 2 ( 4 Ω)
Continuous power output	60 W ⋅ 4 (at 14.4 V, 4 Ω, 20 Hz — 20 kHz 0.2% THD)
	150 W ⋅ 2 (at 14.4 V, 4 Ω, 20 Hz — 20 kHz 0.8% THD)
	75 W ⋅ 4 (at 14.4 V, 2 Ω, 20 Hz — 20 kHz 0.8% THD)
Load impedance	4 Ω (2 — 8 Ω allowable)
	(Bridge connection: 4 — 8 Ω allowable)
Frequency response	10 Hz — 50 kHz (+0 dB, –1 dB)
Signal-to-noise ratio	95 dB (IHF-A network)
Distortion	0.01 % (10 W, 1 kHz)
Separation	70 dB (1 kHz)
Low pass filter	Cut off frequency: 80 Hz
	Cut off slope: –12 dB/oct
High pass filter	Cut off frequency: 80 Hz
	Cut off slope: –12 dB/oct
Gain control	RCA: 400 mV — 6.5 V
	Speaker: 1.6 — 26 V
Maximum input level / impedance	RCA: 6.5 V / 22 kΩ
	Speaker: 26 V / 40 kΩ

Power output ........................................................................................ 60 W RMS ⋅ 4 channels
	(4 Ω and	1 % THD+N)
	150 W RMS ⋅ 2 channels
	(4 Ω and	1 % THD+N)
	75 W RMS ⋅ 4 channels
	(2 Ω and	1 % THD+N)
Signal-to-noise ratio	80 dBA (Reference: 1 W into 4 Ω)

Note:

•Specifications and the design are subject to possible modification without notice due to improvements.

*Average current drawn

•The average current drawn is nearly the maximum current drawn by this unit when an audio signal is input. Use this value when working out total current drawn by multiple power amplifiers.