Pioneer P4800MP Installation, DIN Front/Rear-mount, DIN Front-mount, DIN Rear-mount

Models: P4800MP

1 36
Download 36 pages 35.76 Kb
Page 5
Image 5

MAN-DEH-P4800MP-GB.fm Page 5 Thursday, September 29, 2005 11:55 AM

Installation

Notes

Before making a final installation of the unit, temporarily connect the wiring to confirm that the connections are correct and the system works properly.

Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot – for instance, near a heater outlet.

If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance.

60°

Removing the Unit

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

It becomes easy to remove the frame if the front panel is released.

Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out.

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush

 

Holder

Dashboard

After inserting the holder into the dashboard, then select

the appropriate tabs according to the thickness of the

 

 

dashboard material and bend them.

 

(Install as firmly as possible using the top and bottom

 

tabs. To secure, bend the tabs 90 degrees.)

 

Rubber bush

 

Screw

DIN Rear-mount

Installation using the screw holes on the side of the unit

1.Remove the frame.

To remove the frame, extend top and bottom of the frame outwards in order to unlock it. (When reattaching the frame, point the side with a groove downwards and attach it.)

It becomes easy to remove the frame if the front panel is released.

ENGLISH

5

Page 5
Image 5
Pioneer P4800MP operation manual Installation, DIN Front/Rear-mount, DIN Front-mount, DIN Rear-mount