Pioneer P7500MP Adjusting loudness, Using subwoofer output, Using non fading output

Adjusting loudness
Loudnesscompensates for deficiencies in the
low-and high-sound ranges at low volume.
1 PressAUDIO to select Loud.
PressAUDIO until Loud appears in the dis-
play.
2 Pressato turn loudness on.
Loudnesslevel (e.g., Loud MID) appears in
thedisplay.
3 Presscor dto select a desired level.
Eachpress of cor dselects level in the fol-
lowingorder:
LOW(low)MID (mid)HIGH (high)
4 Pressbto turn loudness off.
LoudOFF appears in the display.
Using subwoofer output
Thisunit is equipped with a subwoofer output
whichcan be turned on or off.
1 PressAUDIO to select Sub-W1.
PressAUDIO until Sub-W1 appears in the dis-
play.
#Whenthe subwoofer controller setting is
PREOUT:FULL, you cannot select Sub-W1.
2 Pressato turn subwoofer output on.
Sub-W1Normal appears in the display. Sub-
wooferoutput is now on.
#Toturn subwoofer output off, press b.
3 Presscor dto select the phase of sub-
wooferoutput.
Presscto select reverse phase and Rev. ap-
pearsin the display. Press dto select normal
phaseand Normal appears in the display.
Adjusting subwoofer settings
Whenthe subwoofer output is on,you can ad-
justthe cut-off frequency and the output level
ofthe subwoofer.
1 PressAUDIO to select Sub-W2.
PressAUDIO until Sub-W2 appears in the dis-
play.
#Whenthe subwoofer output is on, you can se-
lectSub-W2.
2 Presscor dto select cut-off frequency.
Eachpress of cor dselects cut-off frequen-
ciesin the following order:
5080125(Hz)
Onlyfrequencies lower than those in the se-
lectedrange are output from the subwoofer.
3 Pressaor bto adjust the output level
ofthe subwoofer.
Eachpress of aor bincreases or decreases
thelevel of the subwoofer. +6 6is displayed
asthe level is increased or decreased.
Using non fading output
Whenthe non fading output settingis on, the
audiosignal does not pass through this units
lowpass filter (for the subwoofer), but is out-
putthrough the RCA output.
1 PressAUDIO to select non fading out-
puton/off setting.
PressAUDIO until NonFad ON appears in the
display.
#Whenthe subwoofer controller setting is only
PREOUT:FULL, you can switch to the non fading
outputon/off setting. (Refer to page 46.)
2 Pressato turn non fading output on.
NonFadON appears in the display. Non fad-
ingoutput is now on.
#Toturn non fading output off, press b.
Audio Adjustments
En 41
English
Section
09