Pioneer PDP-6100HD manual Screen Size Operation with Computer Signals, Size screen 43 or Sxga

SCREEN SIZE Operation with Computer Signals

Switch to the wide screen mode to expand the 4 : 3 image to fill the entire screen.

1.Press the SCREEN SIZE button on the remote control.

2.Within 3 seconds ...

Press the SCREEN SIZE button again. The screen size switches as follows:

→ 4:3 → FULL → ZOOM

When displaying enhanced split screen:

4:3 ↔ FULL

4:3 size screen (4:3 or SXGA 5:4)

The picture has the same size as the normal computer image.

FULL size screen

The image is expanded in the horizontal direction.

ZOOM size screen

When wide signals are input.

FULL size screen

Information

Supported resolution

See page 27 for details on the display output of the various VESA signal standards supported by the monitor.

“D BY D” , a way of displaying pixels in a one-to-one correspondence with input signals, can be switched only when a 1280 dot x 768 line signal is input.

When 852 (848) dot  480 line wide VGA* signals with a vertical frequency of 60 Hz and horizontal frequency of 31.7 (31.0) kHz are in- put

Select an appropriate setting for RGB SELECT mode referring to the“Table of Signals Supported” on page 27.

*“VGA”, “SVGA” and “SXGA” are registered trademarks of IBM, Inc. of the United States.

Note:

Do not allow the displayed in 4:3 mode for an extended period. This can cause a phosphor burn-in.

English

WIDE Operations

9

En