Pioneer PDR-609 Display messages relating to recording, Additional information, Cause, Remedy

7 Additional information

Display messages relating to recording

Note: In the table below, ** indicates a track number.

Display	Cause	Remedy
Can't COPY	The input signal is digital-copy	Record the source through the analog inputs.
	protected with SCMS.
Can't SYNC	This appears when the SYNCHRO	Record the source manually, or record through the analog input.
	button is pressed when the input
	selector is set to a digital input, and
	the source selected is not recognized
	as CD, MD, DCC, or DAT.
DIN	The digital source was interrupted.	Check that the digital input cable is connected properly and that the
UNLOCK		power of the source player is on.
	The source is not audio, or is an	Check that the source is a regular music source.
	incompatible format (e.g. a CD-
	ROM).
CHECK	The source player was already	Stop the source player. After a short time, SYNCÐ1 or SYNCÐALL
INPUT?	playing when the SYNCHRO	is displayed, and the recorder goes into synchro–record-pause mode.
	button was pressed.
** SET UP	The unit is preparing to record.	Wait until the message disappears.
REPAIR	The recorder was switched	While REPAIR is displayed, the recorder automatically examines the
	off/unplugged after recording without	recorded area of the disc and updates the track numbers and recording
	ejecting the disc. The recorder could	time data. This process takes about 40 minutes for a fully recorded disc.
	not write essential recording	Finalization or further recording is possible once the REPAIR message
	information onto the disc.	disappears.
REC FULL	No more recording is possible	Use another disc, or erase the CD-RW disc.
	because the available recording time
	of the disc has been used up, or 99
	tracks have already been recorded on
	the disc.
pro DISC	The loaded disc is a CD-R or CD-RW	Load a CD-R or CD-RW disc that is designated as being for consumer
	disc for professional use without the	use.
	CONSUMER USE designation.

English

If digital synchro-recording fails to operate correctly, check the following:

1.Pause playback of the source, then press the DIGITAL SYNCHRO button again.

•If you’re recording from a portable CD player, etc., make sure that the shock-protection feature is switched off.

2.Start playback of the source component once you see the SYNCHRO indicator start to blink.

3.If none of the above solves the problem, use manual digital recording to record.

•Digital synchro-recording uses a digital sub-signal contained in the source player’s digital output. Digital synchro-recording will not work when recording from the following devices:

•CD players whose digital output does not include a sub-signal

•Portable CD, MD or DVD players which do not output a digital signal when stopped.

41

En