Locating the Center of the Display
CAUTION: Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the flat panel.
WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SURFACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
| Inverted |
| Display |
| Display |
Tape | Top |
Measure |
|
Display | C |
Bottom | L |
|
Figure 1
1.Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring from outside to outside of the chassis (Figure 1).
Inverted
Display
Marking the
Center of the
Display
C
L
Figure 2
2.Using a pencil lightly mark the center of your flat panel (Figure 2).
Mounting Bracket Positioning
| Left | |
| Mounting | |
Display Bottom | Bracket | |
Right | ||
| ||
| Mounting | |
| Bracket | |
| Arrows Facing | |
| Out |
Figure 3
3.Lay the left and right mounting brackets over the mounting points, with the stamped arrows facing out (Figure 3).
Installation Instructions | Page 5 |
