Pioneer PWM-T210 installation instructions Securing the Mounting Brackets

PWM-T210

C

L

Align the

Mounting

Brackets

Display

Bottom

Figure 4

4.Match the center of viewing guide with the center line you marked in step 1 (Figure 4).

Display

Bottom

Mounting Bracket

	Viewing
Center of	Guide
Display	Center

Figure 5

5.The mounting brackets are designed with a center of viewing guide on the side of them (Figure 5).

Securing the Mounting Brackets

The Griplates™ have M4, M5, M6 and M8 hole patterns to fit the hardware that your flat panel requires.

NOTE: Your plasma uses M8 x 20 or M6 x 12 Phillips screws, use the M8, or M6, mounting points.

1.Once the mounting brackets are aligned secure the Griplate™ to the flat panel (Figure 6).

NOTE: The dimples of the top plates have to be facing up and the bottom dimples must be facing down.

2.Pre-install two (2) M6 x 30 (mm) Phillips pan screws to the bottom of the left and right hand side mounting brackets.

Screwdriver

M4 M5 M6 M8

DIMPLES FACING UP

DIMPLES

FACING UP

DIMPLES

FACING DOWN

Display Bottom

DIMPLES

FACING DOWN

Figure 6

Page 6 Installation Instructions